Novel, visual-attracting traps, accompanying technology, and related behavior of overwintering brown marmorated stink bugs ( Halyomorpha halys Stal)

Read the full article See related articles

Discuss this preprint

Start a discussion What are Sciety discussions?

Listed in

This article is not in any list yet, why not save it to one of your lists.
Log in to save this article

Abstract

Objectives identified as critical for effective management of brown marmorated stink bugs, Halyomorpha halys Stal (BMSB), were addressed in the overwintering life stage. Research was conducted on a 675-acre farm in western Maryland, U.S.A. Developing and testing were done during September – October of each of the years 2013 – 2020. Traps and related materials were developed. Four invented traps plus the development and use of “weed beater” polyethylene plastic in combination with the other traps were used as attractions to BMSB during the overwintering testing periods. Overwintering BMSB showed very little interest other than to find a place to hide that was dry, dark, easy to get into and safe over the winter months (Nielson et al. 2016). Placement of traps show effect of cardinal directions due to heat and light were north = east > west = south of numbers of BMSB. These data were affected by the vegetation, type of buildings such as silos, cabins, houses, etc., around BMSB prior to the en masse flight. Silos were used as attractants from long range during the en masse flight. Five trap types were invented and tested for use against overwintering BMSB found various places such as buildings of any type, pathways in the woods and other habitats present. Trap #1 was made of plastic out of special plant pots, turned upside down with a plastic lid and entry holes top and bottom that allowed the BMSB to reach the hexcel inside and stay there. Trap #2 was made of white, rectangular coroplast and pressed into 0.5 × 0.5 × 7.32 m (5” × 5” × 24”) box also holding hexcel. Traps #1 and #2 are useful for attachment to most anything with BMSB such as the eaves in houses, other buildings, vegetation, crevasses, etc. They can be placed as horizontal or vertical with other ways that enhance efficacy. Both #1 and #2 are cheap and easy to make and use. Trap #3 is made of a cardboard tube, as a fake or “faux” tree (dead and/or dying) in vegetation 20 cm (6-8”) diameter and 1.22 m (3 or 4’) long. The tubes are placed on tomato stakes, have hexcel and holes made as do the others and are placed vertically in the ground. The tubes are covered with small widths of white, black and or burlap around them. Lids of plastic are on top and the trap appears as a dead and/or dying tree. The fourth trap is a “mechanism” or resembling some kind of “Haven” if you will, made of “weed beater” plastic materials 1.98 m (6’6”) wide in brown or black. The materials are placed on trees by wrapping them around 3-4 trees near 4.6 m (10-15’ long). Traps 1 and 2 can then be placed on the outside of the plastic walls and the #3 fake trees can be added around the outside areas. Around 60,000 BMSB were collected and counted in these experiments by the author, and several different factors were raised and addressed to better understand the BMSB behavior during the overwintering stage. The results provide several new tools as well as understanding of approaches to address BMSB management better.

Article activity feed