Power Density and Thermochemical Properties of Hydrogen Magnetohydrodynamic (H2MHD) Generators at Different Pressures, Seed Types, Seed Levels, and Oxidizers

Hydrogen and some of its derivatives (such as e-methanol, e-methane, and e-ammonia) are promising energy carriers that have the potential to replace conventional fuels, thereby eliminating their harmful environmental impacts. An innovative use of hydrogen as a zero-emission fuel is forming weakly ionized plasma by seeding the combustion products of hydrogen with a small amount of an alkali metal vapor (cesium or potassium). This formed plasma can be used as a working fluid in supersonic open-cycle magnetohydrodynamic (OCMHD) power generators. In these OCMHD generators, direct-current (DC) electricity is generated straightforwardly without rotary turbogenerators. In the current study, we quantitatively and qualitatively explore the levels of electric conductivity and the resultant volumetric electric output power density in a typical OCMHD supersonic channel, where thermal equilibrium plasma is accelerated at a Mach number of two (Mach 2) while being subject to a strong applied magnetic field (applied magnetic-field flux density) of five teslas (5 T), and a temperature of 2300 K (2026.85 °C). We varied the total pressure of the pre-ionization seeded gas mixture between 1/16 atm and 16 atm. We also varied the seed level between 0.0625% and 16% (pre-ionization mole fraction). We also varied the seed type between cesium and potassium. We also varied the oxidizer type between air (oxygen–nitrogen mixture, 21–79% by mole) and pure oxygen. Our results suggest that the ideal power density can reach exceptional levels beyond 1000 MW/m3 (or 1 kW/cm3) provided that the total absolute pressure can be reduced to about 0.1 atm only and cesium is used for seeding rather than potassium. Under atmospheric air–hydrogen combustion (1 atm total absolute pressure) and 1% mole fraction of seed alkali metal vapor, the theoretical volumetric power density is 410.828 MW/m3 in the case of cesium and 104.486 MW/m3 in the case of potassium. The power density can be enhanced using any of the following techniques: (1) reducing the total pressure, (2) using cesium instead of potassium for seeding, and (3) using air instead of oxygen as an oxidizer (if the temperature is unchanged). A seed level between 1% and 4% (pre-ionization mole fraction) is recommended. Much lower or much higher seed levels may harm the OCMHD performance. The seed level that maximizes the electric power is not necessarily the same seed level that maximizes the electric conductivity, and this is due to additional thermochemical changes caused by the additive seed. For example, in the case of potassium seeding and air combustion, the electric conductivity is maximized with about 6% seed mole fraction, while the output power is maximized at a lower potassium level of about 5%. We also present a comprehensive set of computed thermochemical properties of the seeded combustion gases, such as the molecular weight and the speed of sound.