Characterizing Deep Brain Stimulation Dual Device Beat Frequency Artifacts
Discuss this preprint
Start a discussion What are Sciety discussions?Listed in
This article is not in any list yet, why not save it to one of your lists.Abstract
Introduction
Recording-enabled deep brain stimulation devices are used to treat individuals with a variety of neurological disorders, but current systems are only able to connect to a maximum of two brain leads. Off-label implantation of additional leads for unique clinical research questions requires bilateral implantable pulse generators (IPGs), however, slight mismatches in clock rates across IPGs produce mismatched stimulation frequencies. This mismatch creates high amplitude beat frequency artifacts (BFA) that occur at regular intervals and contaminate underlying neural signals, presenting unique challenges for future adaptive DBS (aDBS) algorithm development utilizing dual IPGs.
Method
We quantified BFA intervals in local field potential (LFP) recordings from 26 patients implanted with two IPGs during both continuous (cDBS; n=21) and adaptive (aDBS; n=5) stimulation modes.
Results
BFAs occur in all patients at varying intervals and require both devices to be turned on. We found that BFAs result from mismatched stimulation frequencies, where smaller frequency differences result in longer intervals between BFAs. The range in interval length between artifacts was 112 seconds to 30 minutes across patients. Switching to adaptive DBS (aDBS) decreased this interval to 30 seconds in a single patient.
Conclusion
In a dual-device scenario, BFAs should be considered in LFP analysis or future aDBS algorithm design through implementation of mitigation strategies such as onset times and selection of minimally affected recording channels.
